Product Description

This remote switch allows you to turn your dust collector on and off from anywhere in your shop up to 75 feet away, saving you trips to your dust collector whenever you operate a shop machine. Includes two controls with 9 volt batteries. For use on 110 volt dust collectors up to 1 1/2 HP. ... Read more

Product Description

The ECOGATE System is completely automatic, thanks to a simple network of vibration sensors and the microcomputer controller. When a machine is turned on, a sensor signals the controller to open the appropriate gate and to turn on the dust collector. When the machine stops, the gate closes. The startup set includes control unit, four 4" blast gates and four ECOde sensors with 45 foot cables. The Green Box controls up to 9 workstations and a 1 HP dust collector. Use the Power Relay if the dust collector is bigger than 2 HP at 230V. Optional Toroidal Sensor is for single phase workstations with low vibrations. Optional Toroidal Coil is for 1, 2 or 3 phase workstations with low bi-vibrations. Finally, the Greenbox One controls one workstation and dust collector for increased suction. ... Read more

Features

• Easy clip on and off

Product Description

5 styles of elbows in 3 sizes gives you the versatility to create just about any duct run. Well made and intended for tough use. ... Read more

Features

• Connects easily to existing duct work
• Easy to add-on or modify
• More efficient dust pick-up
• No more bolts, screws or duct tape
• Simple to install

Features

• Grounding kit
• 50 feet of wire
• Provides everything you need to ground a dust collection system

Reviews (1)

Not terribly great
What's the point. I can get spare wire and wire nuts to ground my system far cheaper than this. i find the braided copper hard to deal with and am far happier using spare romex I have lying around the shop. Do yourself a favor and make one of these yourself. ... Read more

Product Description

THIS AUCTION IS FOR 2 HOOVER REPLACEMENT HEPA FILTERS THIS HEPA FILTER FITS HOOVER BAGLESS UPRIGHTS THE HOOVER NUMBER THAT RELATES TO THIS FILTER IS #43611042 ... Read more

Features

• Fits ALL Hoover Bagless Upright Vacuums
• HEPA Design
• We Sell 2 for what you'd pay for ONE in the store!

Product Description

Spiral reinforced Clear Hose allows easy inspection for location potential clogs in your duct work. Simple hose clamps secure hose to fittings and hoods. ... Read more

Features

• Use to adapt virtually any power tool to work with all Shop-Vac brand wet/dry vac's
• 1-inch to 2-inch diameter (range)

Reviews (2)

TOOL ADAPTOR
THIS IS THE BEST, AND PROBABLY THE ONLY TOOL ADAPTOR OUT THERE. I HAVE A SHOP VAC THAT HAS 2 DIFFERENT SIZED HOSES THAT DID NOT FIT THE EXHAUST ON MY SANDER, THE COMPANY DID NOT MAKE AN ADAPTOR TO REMEDY THIS PROBLEM, SO I FOUND THE ADAPTOR AT MY LOCAL HARDWARE STORE, CUT IT TO FIT THE SANDER, AND PLACED IT ON MY SHOP VAC HOSE. THE HOSE NOW STAYS ON THE SANDER FOR ALL DIFFERENT TYPES/HEIGHTS OF SANDING. THIS TOOL SOLVED A MAJOR PROBLEM OF KEEPING THE DUST IN MY WORK AREA DOWN. THIS ADAPTOR IS A MUST FOR EVERY OWNER OF A SANDER, ROUTER, PLANER, OR ANY OTHER PORTABLE POWER TOOL THAT GENERATES SOME TYPE OF DUST.

You won't get hosed on this one
I have used a couple of these devices to connect the dust port on tools to vacume hose. Funny how there are standard sizes of dust collection and vacume hoses, but every tool seems to have a dust collection port that is in some odd size. Nothing fits. This adaptor gets in between the odd sizes of tools and standard size of hose. You can easily trim this adaptor to fit either an inside diameter or outside diameter of the adaptor. Like I have said before, it does what it says it will do. ... Read more

Product Description

Hose Adapter for Various BOSCH Sanders. Used on sander model numbers: 1293D, 1295D, 1295DH, 1295DVS, 3107DVS, 3725DVS, 3725DEVS, 3727DVS, 3727DEVS. ... Read more

Features

• Manufactures List Price $5.07 SAVE $2.27
• Used on Model No. 1293D, 1295D, 1295DH, 1295DVS, 3107DVS, 3725DVS, 3725DEVS, 3727DVS, 3727DEVS
• Used on Part No. Vacuum Hose VAC001, VAC009, VAC010 or Vacuum Hose Adapter VAC002

Reviews (1)

fits, but does no good
I bought this adapter for an older 3283dvs sander, which originally came with a flimsy bag filter. I also added a microfilter cartridge. After sanding a kitchen's worth of cabinets and 8 conference room tables, I don't think the system has collected more than a couple of tablespoons of dust. Most of it ends up on the outside of the sander or in the air. Apparently, my sander is just not set up right for the pressurization of the microfilter.

I am a big fan of Bosch tools and believe they are genuinely well-engineered. But I bought this system on their customer support agent's recommendation and wish I hadn't ... Read more

Features

• Fits no. 7810 wet dry vacuum
• Easy to clean and use again
• 5.7 sq. ft of filtering surface
• 99.85% filtration efficiency--great for fine particle pick up
• Washable and reusable for longer service life

Reviews (1)

Dust - Gone and Forgotten
After the first use of the Porter cable square foot exhaust filter I was amazed at the amount of dust that wasnt allover my shop. I am using this filter in a home built filtration system that I built from plans that I found in a magazine. With each use I find that this filter works better than any other filter that I have found. Another reason that I will buy another one when needed is the ease of cleaning. This is by far the best filter that I have found on the market. ... Read more

Features

• Cartridge and collection filter
• 6.25 HP quiet motor
• 22 gallon plastic tank
• Deluxe 2.5" plastic tools
• On-board tool storage

Reviews (5)

Shop-Vac 22-Gallon Wet/Dry Vacuum
I bought this wet/dry vac about a year ago and so far, it has held up well to on the job use. Considering the reasonable price, I feel that it was a very good value and I expect to get another year out of it before replacing it with the same model if still available then. It has excellent suction power although the hose cannot be reversed for blowing. This is probably the main reason why the motor is so mercifully quite. With an empty tank, the vac is light enough for me to easily pick up and load in the truck but still heavy enough to roll smoothly on a concrete or plywood floor. The vac has an eighteen foot long power cord and came with a six-foot 2-1/2 inch diameter locking hose and accessory kit including a floor brush with squeegee, two 2-1/2 foot long extensions, a crevice tool and a disposable fine dust filter bag. I immediately ordered an additional eight-foot locking hose, hose coupling, right-angle brush attachment and two reducer/adapters for connection to my table saw and miter saw when needed.
For regular cleanup, such as woodchips, I just use the included standard wet/dry paper element filter without a bag. When using the vacuum to clean soot from oil burner/gas furnace flues and stack pipes, wood stove/fireplace ash or drywall dust I always use the #90673 high-efficiency fine dust bags and have never had a problem with soot or dust blowing out of the motor exhaust and into the room. These filter bags come in two-packs and are a little expensive but can last for quite a while if you don't use them for everyday cleaning jobs. Of course, the twenty-two gallon tank does have a drain for liquids, but for continuous wet pickup below grade when no sump pit is available, I remove the top motor assembly and use a utility pump with a garden hose to drain the tank rather than try to lift it or fiddle with adapters for the tank drain. Overall, I have been very satisfied with this wet/dry vac and have no problem recommending it.

Poorly designed shop vac
It's simple, the bag won't come out of the vac after it is 2/3 full. It will rip apart first. Would not recommend this product under any circumstances.

nice machine, only minor issues
Just got this model for my first shop vac. All the reviews said it was quiet and had lots of power, and they were right. It is even quieter than I was expecting. I did have a few issues though and will list some pros/cons for readers.

PROs: Long cord, stable base, quiet, lots of power, large size hose, hose screws onto unit for secure connection.

CONS: -short hose.

If you follow the manual for assembly you end up with two plastic washers left over. I went through the manual again and nowhere does it show this piece. I assume that they go on the back wheels since they look the right size and it would make sense, but you have to put them on in the beginning since you hammer a metal cap onto a steel rod and you probably don't want to take it apart. Even the manual says to make sure it is right before you hammer it.

Next problem was that the handle did not line up with the screw holes on one side. Problem was that it fits under a lip in the casing, and so when you line up the screws it didn't fit under the lip. No amount of force would make it work, so I ended up drilling the hole a tiny bit so the screw can fit. It doesn't appear that my minor modification will impact it. In fact you can't even tell I did it, since I could see half the hole and just had to widen it on one side a bit. I don't think that it is a actual defect, and you probably won't have this problem with all of them.

next item is that the picture is wrong. The picture shows 4 casters, but there are only 2 casters in the front. The back has actual wheels. This limits the turning of the unit a bit as straight wheels don't swivl. Second discrepency is that this unit has a bar handle that attaches to the sides and stands up behind the unit. This is a nice bar and allows you to push the unit around with it instead of pulling the hose all the time. I find that the handle also makes a nice place to wrap the cord around.

Packaging of the unit was not the best. They put some cardboard sections in the bottom, but all the attachments were just thrown in either inside the unit or just laying on top of it in the box. Nothing was broken but I would like it better if everything was packaged nice and safe.

The extension wands are plastic, but my very first night I started a bad habit of dropping them on a concrete floor. I am concerned that one day it will shatter as it looks more on the brittle side than the tough rubber side.

A piece not included in the kit is the adapter to connect to standard power tools. (the hose with this thing is too big). They list it as an attachment but it is not part of the unit. (it should be in my opinion)

This really Sucks!
No pun intended. I bought mine recently, and it does a great job around the house/shop. I think it does need a longer hose, though, even though the one it has works well.

Good Basic Vacuum
Great quality unit with great suction. Has all basic accessories needed. Also has a nice unexpected touch - a nice long AC power cord so I don't have to find an extension cord.

But if you are looking to do overhead cleaning (like getting the cobwebs in the corner of the garage) you have to get the extension hose. ... Read more

Product Description

18' Cord, 120V 60 Hz 8.2 Amps. UL Listed Standard Equipment Includes: 1-1/4" Diameter: 7' x 1-1/4" Hose. 2 Extension wands. 12" Floor nozzle with brush and squeegee inserts, crevice tool, round brush, and gulper nozzle 2-1/2" Diameter: 6' x 2-1/2" Hose. 2 Extension wands. 6" Utility nozzle. ... Read more

Features

• Shipping Weight: 20 lbs.
• Tank Size/Style: 6 gal. Metal.
• Dry Capacity: 5 gal.
• Wet Capacity: 4 gal.

Features

• Can be used wet or dry
• Exclusive non-stick surface
• Easy to clean
• Resists clogging
• Reusable

Product Description

Spiral reinforced Clear Hose allows easy inspection for location potential clogs in your duct work. Simple hose clamps secure hose to fittings and hoods. ... Read more

Features

• Hose Size: 1-1/4" Diameter.
• Hose Length: 10'.
• Accessories: Polypropylene Hose.

Product Description

We are the largest supplier of Blast Gates in the U.S.A.! Two types available: ... Read more

Features

• 4 inch ABS plastic
• 4-inch OD ABS plastic
• Economically priced
• Blast gate
• Easy sliding-gate action
• Maximizes dust-collection system efficiency

Product Description

DELUXE FLOOR TOOL ... Read more

Product Description

HEPA Filters 04854913 Miele S300-S600 Original Miele H.E.P.A Filter ... Read more

Reviews (1)

Not too bad
I bought this and found it ok. That is served my purpose ! ... Read more

Product Description

These industrial blast gates can take the abuse of thousands of open and close cycles. Made specifically for production shops. ... Read more

Features

• Connects easily to existing duct work
• Easy to add-on or modify
• More efficient dust pick-up
• No more bolts, screws or duct tape
• Simple to install